Change the Test Variable in Case Steps

1. Open the Load Plan Editor:
• Go to the Steps tab or Exceptions tab in the Load Plan Editor.
2. Select the Case Step:
• In the Steps Hierarchy table, find and select the Case step where you want to change the test variable.
3. Open the Properties Inspector:
• In the Properties Inspector, under the Step Properties section, click Lookup Variable. This action opens the Modify Case Step Dialog.
4. Modify the Test Variable:
• In the Modify Case Step Dialog, click Lookup Variable again to select a new variable for the case step.
5. Follow the Instructions:
• Follow the instructions provided in Table 13-3 for the Case step, which outlines the necessary steps to configure the new test variable.